Environmental Data Management Solutions

Technical Notes for E-DAS Ambient

Run into something not covered clearly in the manual? Check here to see if your specific question is covered, or check our "facts" list and our Frequently Asked Questions (FAQs).

• How do I put meteorological parameters into my AirNow reports?
  
• How do I save my DigiTrend graph settings so I don't have to reconfigure them each time I start the program?
  
• How do I control time synchronization in my system?
  
• How can I add communication delays into my polling to handle radio equipment or old analog cell modems?
  
• How do I copy configuration files using the Copy Files utility?
  
• How do I set up to automatically print my calibration reports?
• Can I collect GPS data into my Model 8832 through the Generic Serial Interface?
  
• I'm new to setting up the AIRNow FTP- how do I set that up?
  
• How do I put meteorological parameters into my AIRNow reports?
  
• How do I save my DigiTrend graph settings so I don't have to reconfigure them each time I start the program?
  
• What are the differences in the three AQI calculation reports?
  
• How do I do a configuration dump from my data logger?
  
• What are the differences between scalar and vector wind speed/direction calculations?
  
• How do I gather my configuration files to e-mail to Agilaire Support?
  
• How do I resolve report viewing errors?
  
• How do I control time synchronization in my system?
  
• How can I add communication delays into my polling to handle radio equipment or old analog cell modems?
  
• How do I copy configuration files using the Copy Files utility?
  
• How do I set up to automatically print my calibration reports?
• E-DAS Version 5.52 now allows for the AQI data to go to Access, but what exactly does that mean?
• How do I configure E-DAS to automatically email data reports or alarm information?